Separate Basic Subassembly (Part 3)

60. CONFIRM THAT UNDERDRIVE BRAKE PISTON MOVES
Using compressed air, confirm that the underdrive brake piston moves smoothly.




61. REMOVE OIL SEAL RINGS
Remove the two oil seal rings.

62. REMOVE FLANGE. PLATES AND DISCS




a. Using SST and press, press in the flange until the snap ring is free from the flange.

SST 09350 - 32014 (09351 - 32070)

b. Using a screwdriver, remove the snap ring.




c. Remove the flange, three plates and discs.




63. REMOVE RETURN SPRING




64. REMOVE UNDERDRIVE BRAKE PISTON
Using low-pressure compressed air (1 kg/sq.cm, 14 psi, 98 kPa), pop out the brake piston into a rag. Force air into the hole shown and remove the brake piston.




65. REMOVE O-RINGS FROM PISTON
Remove the two O-rings from the piston.

66. REMOVE SNAP RING




a. Set SST, and tighten the bolt gradually to compress the springs until the snap ring is free from the spring seat.

SST 09350 - 32014 (09351 - 32040)




b. Using snap ring pliers, remove the snap ring.
c. Remove SST.

SST 09350 - 32014 (09351 - 32040)




67. REMOVE RETURN SPRING
Remove the return spring and snap ring.




68. REMOVE PISTON FROM TRANSMISSION CASE WITH COMPRESSED AIR
a. Apply compressed air into the oil passage of the case to remove the piston.

HINT: Hold the piston so it is not slanted and blow with the gun slightly away from the oil hole.

b. If the piston does not pop out with compressed air, use needle-nose pliers to remove it.




69. REMOVE O-RINGS FROM PISTON
Remove the two O-rings from the piston.




70. REMOVE PARKING LOCK PAWL STOPPER PLATE, TORSION SPRING AND SPRING GUIDE




71. REMOVE PAWL SHAFT CLAMP
Remove the bolt and pawl shaft clamp.




72. REMOVE PARKING LOCK PAWL SHAFT AND LOCK PAWL




73. REMOVE PARKING LOCK SLEEVE




74. REMOVE CAM GUIDE BRACKET
Remove the cam guide bracket as shown.




75. REMOVE MANUAL VALVE SHAFT SPACER
Using a screwdriver and hammer, unstake the spacer and remove it.




76. REMOVE PIN
Using a punch and hammer, drive out the pin.

77. REMOVE MANUAL VALVE SHAFT AND LEVER




a. Remove the retaining spring.




b. Slide out the manual valve shaft and remove the manual valve lever and washer.

78. IF NECESSARY, REPLACE OIL SEAL OF MANUAL SHAFT




a. Using a screwdriver, remove the oil seal.




b. Using a 14 mm socket wrench and hammer, drive in a new oil seal.
c. Apply MP grease to the oil seal lip.




79. REMOVE OIL GALLERY COVER AND GASKET
a. Remove the three bolts.
b. Using a torx wrench, remove the six screws. Remove the gallery cover and gasket.




80. REMOVE B(4) ACCUMULATOR PISTON AND SPRING




81. REMOVE BEARING
Using SST, remove the bearing.

SST 09308 - 00010

82. REMOVE OIL TUBES




a. Remove the four tube clamps from transaxle housing.




b. Using a screwdriver, remove the three (A241E) or four (A241L, A243L) oil tubes.




83. REMOVE OIL TUBE APPLY COVER AND GASKET
Remove the three bolts, and remove the cover and gasket.

84. REMOVE BEARING




a. Remove the bolt and retainer.




b. Using SST, remove the bearing.

SST 09308 - 00010