Removal and Installation

Removal And Installation Of Transaxle Part 1:

Removal And Installation Of Transaxle Part 2:

COMPONENTS

REMOVAL AND INSTALLATION OF TRANSAXLE

Remove and install the parts as shown.

CAUTION: Work must be started after approx. 20 seconds or longer from the time the ignition switch is turned to the "LOCK" position and the negative (-) terminal cable is disconnected from the battery.

MAIN POINT OF INSTALLATION




1. INSTALL TORQUE CONVERTER IN TRANSAXLE
2. CHECK TORQUE CONVERTER INSTALLATION
Using a scale and a straight edge, measure from the installed surface to the front surface of the transaxle housing.

Correct distance: 4A-FE 22.8 mm (0.898 in.)
5S-FE 16.7 mm (0.657 in.)




3. INSTALL TORQUE CONVERTER MOUNTING BOLTS
a. Clean the threads of the bolts with the gasoline.
b. Coat the threads of the bolts with sealer.

Sealer: Part No.08833-00070, THREE BOND 1324 or equivalent.

c. Tighten the bolts evenly.
Torque: 280 kg-cm (20 ft-lb, 27 N.m)