Ignition Coil: Service and Repair

Distributor, Exploded View:

REMOVAL:

1. Remove distributor from vehicle. Refer to DISTRIBUTOR in this section.

2. Remove the distributor cap from the distributor.

3. Remove the ignition rotor, and dust cover.

Ignition Coil Primary Wire Installation:

4. Disconnect the wires from the terminals of the ignition coil.

Ignition Coil Removal:

5. Remove the four retaining screws. Remove ignition coil and dust proof packing.

INSTALLATION:

1. Reinstall coil and packing. Tighten coil retaining screws evenly.

CAUTION: Do not use impact or air tools on ignition coil retaining screws.

Ignition Coil Primary Wire Installation:

2. Reconnect the wires to the terminals of the ignition coil.

Ignition Coil Wires:

NOTE: Ensure the wires are properly inserted into their grooves, located on the side of the ignition coil. Ensure that the wires don't contact the signal rotor or distributor housing.

3. Install the ignition rotor, dust cover, and distributor cap.

4. Install distributor in vehicle. Refer to DISTRIBUTOR in this section.