Disassembly and Assembly

Fig. 5 Exploded View Of Rear Disc Brake Caliper Assembly.:

1. Remove sliding bushing and boot, Fig. 5.
2. Remove piston using compressed air. When using air pressure to remove caliper piston, place a shop towel over piston to prevent it from flying out.
3. Remove caliper boot and piston seal from caliper.
4. Reverse procedure to install, noting the following:
a. Apply suitable grease to the sliding bushing and dust boot, piston seal and piston and caliper dust boot.
b. Ensure dust boot does not fold under during installation.