Disassembly and Assembly

Fig. 3 Front Axle Hub Assembly. Tercel:

1. Remove ball joint from steering knuckle using suitable puller.
2. Remove inner oil seal with screwdriver.
3. Using suitable snap ring pliers, remove snap ring, Fig. 3.
4. Remove brake dust cover attaching bolts, then the dust cover.
5. Using suitable puller, remove axle hub from steering knuckle.
6. Remove bearing inner races and outer oil seal.
7. Place inner race in bearing, then drive bearing from knuckle with hammer and brass drift.
8. Using press and tool No. 09316-60010, press bearing into steering knuckle.
9. Install bearing inner race (outside) and outer oil seal.
10. Install brake dust cover and attaching bolts.
11. Apply suitable grease to outer oil seal lips, then install bearing inner race (inside).
12. Using suitable press, install axle hub in steering knuckle.
13. Install snap ring, inner oil seal and dust deflector (if equipped).