Removal and Installation

REMOVAL
1. DISCONNECT LEVEL WARNING SWITCH CONNECTOR
2. TAKE OUT FLUID WITH SYRINGE

NOTICE: Do not let brake fluid remain on a painted surface. Wash it off immediately.

Disconnecting Brake Lines Using SST:

3. DISCONNECT BRAKE LINES
Using Special Service Tools (SST), disconnect the brake lines from the master cylinder.
SST 09023-00100
Torque: 15 Nm (155 kgf-cm, 11 ft. lbs.)





4. REMOVE MASTER CYLINDER
Remove the 2 mounting nuts and pull out the master cylinder, 2-way and gasket.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)

INSTALLATION
Installation is in the reverse order of removal.
1. BEFORE INSTALLATION, ADJUST LENGTH OF BRAKE BOOSTER PUSH ROD.
2. AFTER INSTALLATION, FILL BRAKE RESERVOIR WITH BRAKE FLUID, BLEED BRAKE SYSTEM, CHECK FOR LEAKS.
3. CHECK AND ADJUST BRAKE PEDAL.