ABS w/Traction Control (TRAC)

REMOVAL
1. REMOVE RIGHT FRONT FENDER LINER
2. REMOVE A/C TUBE CLAMP BRACKET BOLT
3. REMOVE P/S HOSE CLAMP BOLT





4. DISCONNECT BRAKE LINES
Using Special Service Tools (SST), disconnect the 6 brake lines from the ABS & TRAC actuator.
SST 09751-36011
Torque:
10 mm nut: 15 Nm (155 kgf-cm, 11 ft. lbs.)
12 mm nut: 20 Nm (200 kgf-cm, 14 ft. lbs.)
5. REMOVE ABS & TRAC ACTUATOR ASSEMBLY
a. Disconnect the 2 connectors.
b. Remove the 2 bolts, 2 nuts and actuator assembly.
Torque: 19 Nm (195 kgf-cm, 14 ft. lbs.)
5. REMOVE ABS & TRAC ACTUATOR
a. Remove the 2 nuts and ABS & TRAC actuator from actuator bracket.
Torque: 5.4 Nm (55 kgf-cm, 48 inch lbs.)
b. Remove the 2 holders and 3 cushions from the ABS & TRAC actuator.

INSTALLATION
Installation is in the reverse order of removal.
AFTER INSTALLATION, FILL BRAKE RESERVOIR WITH BRAKE FLUID, BLEED BRAKE SYSTEM, AND CHECK FOR LEAKS.