Parking Brake Pedal: Service and Repair

REMOVAL
1. REMOVE INSTRUMENT LOWER PANEL AND FINISH LOWER LH PANEL.
2. REMOVE JUNCTION BLOCK
3. REMOVE PARKING BRAKE PEDAL BRACKET ASSEMBLY
a. Remove the 3 bolts.
Torque: 61 Nm (620 kgf-cm, 45 ft. lbs.)
b. Remove the 2 clips and pin, and disconnect parking brake cable No. 1.
c. Remove the 2 screws, and disconnect the release cable.
Torque: 2.7 Nm (28 kgf-cm, 24 inch lbs.)
d. Disconnect the connector, and remove the parking brake switch.





4. IF NECESSARY, REMOVE SHOCK ABSORBER
a. Loosen the union lock nut.
Torque: 13 Nm (130 kgf-cm, 9 ft. lbs.)
b. Remove the shock absorber.

HINT: At the time of installation, please refer to the following items:
- Install the shock absorber to the pin on the pedal bracket side, then extend the piston rod fully.
- Return the pedal until it hits the cushion.
- Make adjustments so that the shock absorber's union and the pin on the pedal side are aligned, then turn the union 1 turn counterclockwise.

INSTALLATION
Installation is in the reverse order of removal.
AFTER INSTALLATION, ADJUST PARKING BRAKE PEDAL TRAVEL.