Throttle Body: Service and Repair

COMPONENTS

REMOVAL




1. DRAIN ENGINE COOLANT
2. DISCONNECT ACCELERATOR CABLE
3. DISCONNECT THROTTLE CABLE

4. REMOVE AIR CLEANER HOSE
a. Disconnect the PCV hose.
b. Loosen the 2 hose clamps, and remove the air cleaner hose.




5. REMOVE THROTTLE BODY
a. Disconnect the throttle position sensor connector.
b. Disconnect the IAC valve connector.

c. Disconnect these hoses:
1. Water bypass hose (from intake manifold)
2. Water bypass hose (from water inlet housing)
3. Air assist hose




d. Remove the 2 bolts, 2 nuts, EGR gas temperature sensor connector, throttle body and gasket.

HINT: At the time of installation, please refer to the following items.
Place a new gasket on the air intake chamber.

Torque: 19.5 N.m (200 kgf.cm, 14 ft.lbf)

INSTALLATION
Installation is in the reverse order of removal.