Roof Drip Side Finish Moulding

Roof Drip Side Finish Moulding:

REMOVAL

REMOVE ROOF DRIP SIDE FINISH MOULDING
a. Using a drill of less than 3.0 mm (0.118 in.), drill out the 10 rivet heads.

HINT: Gently and vertically put the drill to the rivet, and cut the rivet flanges.

CAUTION: Take care as the cut rivet is hot.

NOTE: Prizing the hole with a drill can lead to damage to the rivet hole or breaking the drill.

b. Remove the roof drip side finish moulding.

INSTALLATION

INSTALL ROOF DRIP SIDE FINISH MOULDING
Using a air riveter with nose piece No.1 or hand riveter with nose piece No.1, install the 10 rivets to the roof drip side finish moulding.

NOTE:




- Do not prize a riveter, as riveter is damaged, it is not tightened and the mandrel is bent.




- Do not tilt the riveter and disconnect the rivet from the material while handling a riveter, as the materials are not tightened firmly.




- Install the rivet while attaching materials, as they are not tightened firmly.