CAN Communication System
TERMINALS OF ECUTerminals Of ECU:
Pinouts:
1. DLC3
a. Check DLC3.
1. Turn the ignition switch off.
2. Measure the resistance according to the value(s) in the table shown.
Terminals Of ECU:
Pinouts:
2. SKID CONTROL ECU
a. Check skid control ECU.
1. Turn the ignition switch off.
2. Disconnect the connector (S1) from the skid control ECU.
3. Measure the resistance according to the value(s) in the table shown.
Terminals Of ECU:
Pinouts:
b. Check the skid control ECU harness side connector (S1).
1. Turn the ignition switch off.
2. Disconnect the connector (S1) from the skid control ECU.
3. Measure the resistance according to the value(s) in the table shown.
3. STEERING SENSOR
Terminals Of ECU:
Pinouts:
a. Check steering sensor.
1. Turn the ignition switch off.
2. Disconnect the connector (S11) from the steering sensor.
3. Measure the resistance according to the value(s) in the table shown.
Terminals Of ECU:
Pinouts:
b. Check the harness side connector (S11) of the steering sensor.
1. Turn the ignition switch off.
2. Disconnect the connector (S11) from the steering sensor.
3. Measure the resistance according to the value(s) in the table shown.
Terminals Of ECU:
Pinouts:
4. YAW RATE SENSOR
a. Check the yaw rate sensor harness side connector (Y1).
1. Turn the ignition switch off.
2. Disconnect the connector (Y1) from the yaw rate sensor.
3. Measure the resistance according to the value(s) in the table shown.