Front Seat Outer Belt Assy With Airbag Assembly Deployment

DISPOSAL

HINT: When scrapping vehicles equipped with a seat belt pretensioner or disposing of a front seat outer belt (with seat belt pretensioner) always first active the seat belt pretensioner in accordance with the procedures described below. If any abnormality occurs in the seat belt pretensioner operation, contact the SERVICE DEPT. of the TOYOTA MOTOR SALES, U.S.A., INC. When disposing of a front seat outer belt (with seat belt pretensioner) activated in a collision, follow the same procedures given in step 1-(d) in DISPOSAL.

CAUTION:
- Never dispose of front seat outer belt which has an inactivated pretensioner.
- The seat belt pretensioner produces a sizeable exploding sound when it activates, so perform operation out-of-door and where it will not create a nuisance to nearby residents.




- When activating a front seat outer belt (with seat belt pretensioner), perform the operation at least 10 m (33 ft) away from the front seat outer belt.
- Use gloves and safety glasses when handling a front seat belt with an activated pretensioner.
- Always wash your hands with water after completing operation.
- Do not apply water, etc. to a front seat outer belt with an activated pretensioner.
- When activating the seat belt pretensioner, always use the specified SST. (09062-00700, 09082-00770) (SRS Airbag Deployment Tool) Perform the operation in a place away from electrical noise.

DISPOSE OF FRONT SEAT OUTER BELT ASSEMBLY RH (WHEN DISPOSING OF AIRBAG ASSEMBLY DEPLOYMENT METHOD)

NOTE:
- When disposing of a front seat outer belt (with seat belt pretensioner) only, never use the customer's vehicle to activate the seat belt pretensioner.
- Be sure to follow the procedures given when activating the seat belt pretensioner.




a. Remove the front seat outer belt.

HINT: Cut the belt near the seat belt retractor.




b. Check functioning of SST (See step 1-(a)).




c. Install SST.
1. Connect 2 SST then connect them to the seat belt pretensioner.

NOTE: To avoid damaging SST connector and wire harness, do not lock the secondary lock of the twin lock.




2. Place the front seat outer belt on the ground and cover it with the disc wheel with tire.

NOTE: Place the front seat outer belt as shown in the illustration.

3. Move SST at least 10 m (33 ft) away from the wheel disc.

NOTE: Take care not to damage SST wire harness.




d. Activate the seat belt pretensioner.
1. Connect SST red clip to the battery positive (+) terminal and black clip to the battery negative (-) terminal.
2. Check that no one is within 10 m (33 ft) area around the disc wheel.
3. Press SST activation switch and activate the seat belt pretensioner.

HINT: The seat belt pretensioner operates simultaneously with the LED of SST activation switch lighting up.




e. Dispose of the front seat outer belt (with seat belt pretensioner).
1. Remove the disc wheel and SST.
2. Place the front seat outer belt in a vinyl bag, tie the end tightly and dispose of it in the same way as other general parts.