Without Scan Tool

DTC CHECK (USING SST CHECK WIRE)

Check DTCs using a SST check wire.




1. Using SST, connect terminals TC and CG of the DLC3.
SST 09843-18040

2. Turn the ignition switch to the ON position.
3. Read the DTC from the ABS warning light on the combination meter.

HINT:
- If no code appears, inspect the diagnostic circuit or ABS warning light circuit.
- As an example, the blinking patterns for a normal system code and codes 11 and 21 are shown.





4. Codes are explained in the code table.

If 2 or more DTCs are detected at the same time, the lowest numbered DTC is displayed first.

5. After completing the check, remove the SST from the DLC3.