Rear

REPLACEMENT
1. REMOVE REAR WHEEL
2. REMOVE REAR BRAKE DRUM SUB-ASSY
3. DISCONNECT SKID CONTROL SENSOR WIRE (W/ ABS)





4. REMOVE REAR AXLE HUB & BEARING ASSY LH
a. Remove the 4 bolts and hub & bearing assy LH.





5. INSTALL REAR AXLE HUB & BEARING ASSY LH
a. Install the hub & bearing assy LH with the 4 bolts.
Torque: 61 Nm (622 kgf-cm, 45 ft. lbs.)
6. CONNECT SKID CONTROL SENSOR WIRE (W/ ABS)





7. INSPECT BEARING BACKLASH
a. Set a dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 inch)
If the backlash exceeds the maximum, replace the rear axle hub & bearing assy LH.





8. INSPECT AXLE HUB DEVIATION
a. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 inch)
If the backlash exceeds the maximum, replace the rear axle hub & bearing assy LH.
9. INSTALL REAR BRAKE DRUM SUB-ASSY
10. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
11. CHECK ABS SPEED SENSOR SIGNAL (W/ ABS)