Crankshaft: Specifications

Crankshaft
Thrust clearance
STD 0.090 - 0.190 mm (0.00354 - 0.00748 inch)
Maximum 0.30 mm (0.012 inch)
Thrust washer thickness 2.430 - 2.480 mm (0.09567 - 0.09764 inch)
Main journal oil clearance
STD 0.010 - 0.023 mm (0.0004 - 0.0009 inch)
Maximum 0.07 mm (0.0028 inch)
Main journal diameter
Reference
Mark 0 46.000 - 46.002 mm (1.81102 - 1.81110 inch)
Mark 1 46.002 - 46.004 mm (1.81110 - 1.81118 inch)
Mark 2 46.004 - 46.006 mm (1.81118 - 1.81126 inch)
Mark 3 46.006 - 46.008 mm (1.81126 - 1.81133 inch)
Mark 4 46.008 - 46.010 mm (1.81133 - 1.81141 inch)
Mark 5 46.010 - 46.012 mm (1.81141 - 1.81149 inch)
Main bearing center wall thickness
Reference
Mark 1 1.992 - 1.995 mm (0.07843 - 0.07854 inch)
Mark 2 1.995 - 1.998 mm (0.07854 - 0.07866 inch)
Mark 3 1.998 - 2.001 mm (0.07866 - 0.07878 inch)
Mark 4 2.001 - 2.004 mm (0.07878 - 0.07890 inch)
Crank pin diameter 39.992 - 40.000 mm (1.5745 - 1.5748 inch)
Circle run out Maximum 0.03 mm (0.00 12 inch)
Main journal taper and out-of round Maximum 0.02 mm (0.0008 inch)
Crank pin taper and out-of round Maximum 10.02 mm (0.0008 inch)
Crankshaft position sensor x Timing chain cover
Bolt A 7.5 Nm (76 kgf-cm, 66 inch lbs.)
Bolt B 11 Nm (112 kgf-cm, 8 ft. lbs.)
Oil control valve 8.0 Nm (82 kgf-cm, 71 inch lbs.)