Removal and Installation

REMOVAL
1. REMOVE REAR WHEEL
2. REMOVE BRAKE DRUM
3. CHECK BEARING BACKLASH AND AXLE HUB DEVIATION





a. Set a dial indicator near the center of the axle hub and check the backlash in the bearing shaft direction.
Maximum: 0.05 mm (0.0020 inch)
If the backlash exceeds the maximum, replace the axle hub assembly.





b. Using a dial indicator, check the deviation at the surface of the axle hub outside the hub bolt.
Maximum: 0.07 mm (0.0028 inch)
If the deviation exceeds the maximum, replace the axle hub assembly.
4. w/ ABS: DISCONNECT ABS SPEED SENSOR CONNECTOR





5. REMOVE AXLE HUB ASSEMBLY
a. Remove the 4 bolts and axle hub assembly.
b. Support the rear brake assembly securely.

INSTALLATION
1. INSTALL AXLE HUB ASSEMBLY
Install the axle hub assembly with the 4 bolts.
Torque: 52 Nm (526 kgf-cm, 38 ft. lbs.)
2. w/ABS: CONNECT ABS SPEED SENSOR CONNECTOR TO AXLE HUB ASSEMBLY
3. CHECK BEARING BACKLASH AND AXLE HUB DEVIATION
4. INSTALL BRAKE DRUM
5. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
6. w/ ABS: CHECK ABS SPEED SENSOR SIGNAL