Transmission Temperature Sensor/Switch: Service and Repair
ATF TEMPERATURE SENSORON-VEHICLE REPAIR
1. DISCONNECT SOLENOID CONNECTOR
2. REMOVE LH ENGINE UNDER COVER
3. REMOVE DRAIN PLUG AND DRAIN ATF
4. REMOVE OIL PAN AND GASKET
NOTICE: Some fluid will remain in the oil pan. Remove the 19 bolts, and carefully remove the oil pan assembly. Discard the gasket.
5. REMOVE OIL STRAINER
a) Remove the 3 bolts and oil strainer.
b) Remove the O-ring.
6. DISCONNECT 5 SHIFT SOLENOID VALVE CONNECTORS
7. REMOVE ATF TEMPERATURE SENSOR
a) Remove the bolt and lock plate, and remove the ATF temperature sensor.
b) Remove the O-ring from the ATF temperature sensor.
8. INSTALL ATF TEMPERATURE SENSOR
a) Coat a new O-ring with ATF and it to the direct clutch speed sensor.
b) Install the ATF temperature sensor with the lock plate and bolt.
Torque: 11 Nm (110 kgf-cm, 8 ft. lbs.)
9. CONNECT 5 SHIFT SOLENOID VALVE CONNECTORS
10. INSTALL OIL STRAINER
a) Coat a new O-ring with ATF.
b) Install the O-ring to the oil strainer.
c) Install the oil strainer with the 3 bolts.
Torque: 11 Nm (110 kgf-cm, 8 ft. lbs.)
11. INSTALL OIL PAN
Install the oil pan and a new gasket with the 19 bolts.
Torque: 7.8 Nm (80 kgf-cm, 69 inch lbs.)
12. INSTALL DRAIN PLUG
Install a new gasket and drain plug.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
13. CONNECT SOLENOID CONNECTOR
14. FILL ATF AND CHECK ATF LEVEL
15. INSTALL LH ENGINE UNDER COVER