With Manufacturer's Scan Tool

Using hand-held tester:
Check the DTC

NOTE:
The hand-held tester only:
When the diagnosis system is switched from the normal mode to the check mode, it erases all DTCs and freezed frame data recorded in the normal mode. So before switching the modes, always check the DTCs and freezed frame data, and note them down.

1. Prepare the OBD II scan tool (complying with SAE J 1978) or hand-held tester.




2. Connect the OBD II scan tool or hand-held tester to the DLC3 under the instrument panel lower pad.

3. Turn the ignition switch ON and push the OBD II scan tool or hand-held tester switch ON.

4. Use the OBD II scan tool or hand-held tester to check the DTCs and freeze frame data; note them down. (For operating instructions, see the OBD II scan tool's instruction book.)

5. See Trouble Code Descriptions to confirm the details of DTCs.