Without Scan Tool

CLEAR DTC

Not using SST (diagnosis check wire No. 2):

CLEAR DTC

When the ignition switch is turned off, the DTC is cleared.

HINT: DTC might not be cleared by turning the ignition switch OFF. In this case, proceed to the next step.

Using SST (diagnosis check wire No. 2):

CLEAR DTC

SST 09843-18040

a. Connect two SST to terminals Tc and A/B of the DLC3.
b. Turn the ignition switch ON, and wait for approx. 6 seconds.




c. Starting with terminal Tc, ground alternately terminal Tc and terminal A/B twice each in cycles of 1.0 second. Make sure that the terminals are grounded. Ensure terminal Tc remain grounded.

HINT: When alternately grounding terminals Tc and A/B, release ground from one terminal and immediately ground the other terminal within an interval of 0.2 seconds. If DTCs are not cleared, repeat the above procedure until the codes are cleared.

d. Several seconds after doing the clearing procedure, the SRS warning light will blink in a 50 msec. cycle to indicate the codes which have been cleared.