Rear Axle LH Hub Bolt Replacement

REPLACEMENT

HINT:
COMPONENTS:
FF: See Diagrams; Exploded Views; Rear Axle Hub & Bearing LH.
4WD: See Axle Shaft Assembly; Diagrams; Exploded Views; Rear Axle Carrier LH.

1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSY, LH (DISC REAR BRAKE TYPE)
3. REMOVE REAR DISC (DISC REAR BRAKE TYPE)
4. SEPARATE REAR STABILIZER LINK ASSY LH (4WD DRIVE TYPE)
5. REMOVE REAR AXLE SHAFT LH NUT (4WD DRIVE TYPE)
SST 09930-00010
6. REMOVE REAR BRAKE DRUM SUB-ASSY (DRUM REAR BRAKE TYPE)
7. SEPARATE SPEED SENSOR REAR LH (4WD DRIVE TYPE)
8. REMOVE PARKING BRAKE SHOE STRUT SET LH (4WD DRIVE TYPE)
SST 09703-30010
9. REMOVE FRONT BRAKE SHOE (4WD DRIVE TYPE)
SST 09718-00010
10. REMOVE REAR BRAKE AUTOMATIC ADJUST LEVER LH (4WD DRIVE TYPE)
11. REMOVE REAR BRAKE SHOE (4WD DRIVE TYPE)
SST 09718-00010
12. SEPARATE PARKING BRAKE CABLE ASSY No. 3 (4WD DRIVE TYPE)
13. SEPARATE REAR BRAKE TUBE No. 4 (4WD DRIVE TYPE)
SST 09023-00100
14. SEPARATE REAR SUSPENSION ARM ASSY No. 1 LH (4WD DRIVE TYPE)
15. SEPARATE UPPER CONTROL ARM ASSY (4WD DRIVE TYPE)
16. REMOVE AXLE ASSY RR LH (4WD DRIVE TYPE)
17. REMOVE REAR WHEEL BEARING DUST DEFLECTOR No. 1 LH (4WD DRIVE TYPE)
18. REMOVE REAR AXLE HUB & BEARING ASSY LH (4WD DRIVE TYPE)





19. REMOVE REAR AXLE LH HUB BOLT (2WD DRIVE TYPE)
a. Using SST and a hammer handle or an equivalent, remove the LH hub bolt.
SST 09628-10011





20. REMOVE REAR AXLE LH HUB BOLT (4WD DRIVE TYPE)
a. Using a press, remove the LH hub bolt.





21. INSTALL REAR AXLE LH HUB BOLT (2WD DRIVE TYPE)
a. Install a washer and nut to a new LH hub bolt as shown in the illustration.
b. Using a hammer handle or an equivalent to hold the hub & bearing assy, install the LH hub bolt by tightening the nut.





22. INSTALL REAR AXLE LH HUB BOLT (4WD DRIVE TYPE)
a. Using a press and an extension bar, install a new LH hub bolt.
23. INSTALL REAR AXLE HUB & BEARING ASSY LH (4WD DRIVE TYPE)
24. INSTALL REAR WHEEL BEARING DUST DEFLECTOR No. 1 LH (4WD DRIVE TYPE)
SST 09608-10010, 09950-60020 (09951-00680), 09950-70010 (09951-07100)
25. TEMPORARY TIGHTEN UPPER CONTROL ARM ASSY (4WD DRIVE TYPE)
26. INSTALL AXLE ASSY RR LH (4WD DRIVE TYPE)
27. TEMPORARY TIGHTEN REAR SUSPENSION ARM ASSY No. 1 LH (4WD DRIVE TYPE)
28. INSTALL REAR BRAKE TUBE No. 4 (4WD DRIVE TYPE)
SST 09023-00100
29. CONNECT PARKING BRAKE CABLE ASSY No. 3 (4WD DRIVE TYPE)
30. APPLICATION HIGH TEMPERATURE GREASE (4WD DRIVE TYPE)
31. INSTALL REAR BRAKE SHOE (4WD DRIVE TYPE)
SST 09718-00010
32. INSTALL REAR BRAKE AUTOMATIC ADJUST LEVER LH (4WD DRIVE TYPE)
33. INSTALL FRONT BRAKE SHOE (4WD DRIVE TYPE)
SST 09718-00010
34. INSTALL PARKING BRAKE SHOE STRUT SET LH (4WD DRIVE TYPE)
35. SPEED SENSOR REAR LH (4WD DRIVE TYPE)
36. CHECK REAR DRUM BRAKE INSTALLATION (4WD DRIVE TYPE)
37. INSTALL REAR BRAKE DRUM SUB-ASSY (DRUM REAR BRAKE TYPE)
38. INSTALL REAR AXLE SHAFT LH NUT (4WD DRIVE TYPE)
39. REMOVE REAR BRAKE DRUM SUB-ASSY (4WD DRIVE TYPE)
40. INSPECT BEARING BACKLASH (4WD DRIVE TYPE)
41. INSPECT AXLE HUB DEVIATION (4WD DRIVE TYPE)
42. INSTALL REAR BRAKE DRUM SUB-ASSY (4WD DRIVE TYPE)
43. ADJUST REAR DRUM BRAKE SHOE CLEARANCE (4WD DRIVE TYPE)
44. INSTALL REAR AXLE SHAFT LH NUT (4WD DRIVE TYPE)
45. INSTALL REAR STABILIZER LINK ASSY LH (4WD DRIVE TYPE)
46. BLEED BRAKE LINE (4WD DRIVE TYPE)
47. INSTALL REAR DISC (DISC REAR BRAKE TYPE)
48. INSTALL REAR DISC BRAKE CALIPER ASSY, LH (DISC REAR BRAKE TYPE)
49. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
50. STABILIZE SUSPENSION (4WD DRIVE TYPE)
51. FULLY TIGHTEN UPPER CONTROL ARM ASSY (4WD DRIVE TYPE)
52. FULLY TIGHTEN REAR SUSPENSION ARM ASSY No. 1 LH (4WD DRIVE TYPE)
53. CHECK FLUID LEVEL IN RESERVOIR (4WD DRIVE TYPE)
54. INSPECT AND ADJUST REAR WHEEL ALIGNMENT (4WD DRIVE TYPE)
55. CHECK ABS SPEED SENSOR SIGNAL (4WD DRIVE TYPE)