Reassembly Procedure

1. Install Rear Door Glass Sub-assembly.

A. Install the glass run.





B. Install the door glass to the window regulator with the 2 bolts.

Torque: 8.0 Nm (82 kgf.cm, 71 in.lbf)

NOTE:
Be careful not to damage the glass.





2. Install Rear Door Window Guide Sub-assembly Rear.

A. Replace the rear door guide seal.

B. Install the guide seal with the 3 screws (A).

C. Install the window guide rear with the screw (B) and bolt.





3. Install Rear Door Service Hole Cover.

A. Apply butyl tape to the door.

B. Install a new service hole cover.

HINT:

^ When installing the service hole cover, pull out the links and connectors through the service hole cover.

^ There should be no wrinkles or folds after attaching the service hole cover.

^ After attaching the service hole cover, check the sealing quality.

C. Install the trim bracket with the 2 screws.





4. Install Rear Door Window Frame Molding.

A. Remove the tape from the molding.

B. Clean the contact surface of the body and outer edges of the molding with a wax, grease and silicone remover, such as Kent Acrysol.

C. Apply new double-sided tape to the molding.





Specification:

D. Using a heat light, heat the body and molding.

E. Remove the peeling paper from the molding face.

F. Install the molding with the screw.

HINT:
When installing the molding, heat the body and molding using a heat light.





Heating temperature:

NOTE:
Do not heat the body and molding excessively.