Instrument Panel Sub-Assy Lower
Instrument Panel/Meter:
INSTRUMENT PANEL SUB-ASSY LOWER
REPLACEMENT
HINT:
- Installation is in the reverse order of removal.
1. TABLE OF BOLT, SCREW AND NUT
2. DISCONNECT BATTERY NEGATIVE TERMINAL
3. REMOVE INSTRUMENT PANEL SUB-ASSY W/PASSENGER AIRBAG ASSY
4. REMOVE STEERING WHEEL COVER LOWER NO.2
5. REMOVE STEERING WHEEL COVER LOWER NO.3
6. REMOVE HORN BUTTON ASSY
7. REMOVE STEERING WHEEL ASSY
SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)
8. REMOVE TILT LEVER BRACKET
9. REMOVE STEERING COLUMN COVER
10. REMOVE TURN SIGNAL SWITCH ASSY W/SPIRAL CABLE SUB-ASSY
11. REMOVE FRONT DOOR SCUFF PLATE LH
12. REMOVE FRONT DOOR SCUFF PLATE RH
13. REMOVE COWL SIDE TRIM BOARD LH
14. REMOVE COWL SIDE TRIM BOARD RH
15. REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSY CENTER
a. Remove the 2 screws .
b. Disengage the 4 clips and then remove the instrument cluster finish panel assy center.
16. REMOVE CENTER CLUSTER CUSHION NO.1
17. REMOVE RADIO RECEIVER ASSY W/STEREO OPENING COVER
18. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER
a. Using a clip remover, remove the clip from the instrument panel finish panel lower center.
b. Disengage the 4 claws and the 2 clips, and then remove the instrument panel finish panel lower center.
19. REMOVE GLOVE COMPARTMENT DOOR LOCK COVER
a. Disengage the 6 claws and then remove the glove compartment door lock cover.
20. REMOVE GLOVE COMPARTMENT DOOR LOCK ASSY
a. Remove the 4 screws and then the glove compartment door lock assy.
21. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER
a. Disengage the 4 claws and then remove the instrument panel finish panel lower.
22. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSY NO.1
a. Disengage the 2 claws and then remove the instrument panel under cover sub-assy No.1.
23. REMOVE POWER STEERING ECU ASSY
24. REMOVE SHIFT LEVER ASSY LWR
25. REMOVE INSTRUMENT PANEL SUB-ASSY LOWER
a. Using a clip remover, remove the 8 clips from the duct and the instrument panel sub-assy lower.
b. Remove the 4 bolts
c. Remove the screw , and the screw
d. Disconnect all connectors, and disengage all clamps. Make sure the wire harness is not caught on anything, and then remove the instrument panel sub-assy lower.
26. REMOVE GLOVE COMPARTMENT PLATE
a. Remove the 2 screws .
b. Disengage the 2 claws and then remove the glove compartment plate.
27. REMOVE INSTRUMENT PANEL CUSHION LOWER NO.1
28. INSTALL SHIFT LEVER ASSY LWR
29. INSTALL POWER STEERING ECU ASSY
30. INSTALL INSTRUMENT PANEL SUB-ASSY W/PASSENGER AIRBAG ASSY
31. INSTALL TILT LEVER BRACKET
32. ADJUST SPIRAL CABLE SUB-ASSY
33. INSTALL STEERING WHEEL ASSY
34. INSTALL HORN BUTTON ASSY
35. CONNECT BATTERY NEGATIVE TERMINAL
36. INSPECT HORN BUTTON ASSY
37. INSPECT SRS WARNING LIGHT
38. PERFORM INITIALIZATION
39. PERFORM CALIBRATION OF TORQUE SENSOR ZERO POINT