Camshaft Position Sensor: Service and Repair

CAMSHAFT POSITION SENSOR

REPLACEMENT
1. PRECAUTION
2. REMOVE RADIATOR SUPPORT OPENING COVER
3. REMOVE ENGINE UNDER COVER LH
4. REMOVE ENGINE UNDER COVER RH
5. DRAIN HV COOLANT
6. REMOVE REAR FLOOR BOARD NO.2
7. REMOVE DECK FLOOR BOX REAR
8. REMOVE REAR FLOOR BOARD NO.3
9. DISCONNECT ENGINE WIRE NO.3 (BATTERY NEGATIVE TERMINAL)
10. REMOVE SERVICE PLUG GRIP
11. REMOVE WINDSHIELD WIPER ARM COVER
12. REMOVE FR WIPER ARM RH
13. REMOVE FR WIPER ARM LH
14. REMOVE HOOD TO COWL TOP SEAL
15. REMOVE COWL TOP VENTILATOR LOUVER LH
16. REMOVE COWL TOP VENTILATOR LOUVER RH
17. REMOVE WINDSHIELD WIPER LINK ASSY
18. REMOVE COWL TOP PANEL SUB-ASSY OUTER FRONT
19. REMOVE INVERTER COVER
20. VERIFY THAT VOLTAGE OF W/CONVERTER INVERTER ASSY IS 0 V
21. DISCONNECT INVERTER COOLING HOSE NO.2
22. DISCONNECT INVERTER COOLING HOSE NO.1
23. DISCONNECT INVERTER COOLING HOSE NO.6
24. SEPARATE CIRCUIT BREAKER SENSOR NO.1
25. DISCONNECT FRAME WIRE NO.2
26. REMOVE W/CONVERTER INVERTER ASSY




27. REMOVE CAMSHAFT POSITION SENSOR
a. Disconnect the camshaft position sensor connector.
b. Remove the bolt, then remove the camshaft position sensor.




28. INSTALL CAMSHAFT POSITION SENSOR
a. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
b. Install the camshaft position sensor with the bolt.
Torque: 8.0 Nm (82 kgf.cm, 71 in.lbf)

NOTE: Be careful that the O-ring is not cracked or jammed when installing.

c. Connect the camshaft position sensor connector.

29. INSTALL W/CONVERTER INVERTER ASSY
30. CONNECT FRAME WIRE NO.2
31. CONNECT CIRCUIT BREAKER SENSOR NO.1
32. CONNECT INVERTER COOLING HOSE NO.6
33. CONNECT INVERTER COOLING HOSE NO.1
34. CONNECT INVERTER COOLING HOSE NO.2
35. INSTALL INVERTER COVER
36. INSTALL COWL TOP PANEL SUB-ASSY OUTER FRONT
37. INSTALL WINDSHIELD WIPER LINK ASSY
38. INSTALL SERVICE PLUG GRIP
39. CONNECT ENGINE WIRE NO.3 (BATTERY NEGATIVE TERMINAL)
40. ADD HV COOLANT
41. CHECK FOR HV COOLANT LEAKS
42. CHECK FOR ENGINE OIL LEAKS
43. INSTALL COWL TOP VENTILATOR LOUVER RH
44. INSTALL COWL TOP VENTILATOR LOUVER LH
45. INSTALL HOOD TO COWL TOP SEAL
46. INSTALL FR WIPER ARM LH
47. INSTALL FR WIPER ARM RH
48. INSTALL WINDSHIELD WIPER ARM COVER
49. INSTALL REAR FLOOR BOARD NO.3
50. INSTALL DECK FLOOR BOX REAR
51. INSTALL REAR FLOOR BOARD NO.2
52. INSTALL ENGINE UNDER COVER RH
53. INSTALL ENGINE UNDER COVER LH
54. INSTALL RADIATOR SUPPORT OPENING COVER
55. POWER WINDOW CONTROL SYSTEM INITIALIZE