Wheel Bearing: Service and Repair

REAR AXLE HUB & BEARING ASSY LH
REPLACEMENT

HINT: Refer to components Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL
2. REMOVE REAR BRAKE DRUM SUB-ASSY
3. SEPARATE SKID CONTROL SENSOR WIRE
a. Disconnect the skid control sensor connector.

NOTICE: Be careful that any foreign matter do not attach inside the skid control sensor connector and on the installation portion.





4. REMOVE REAR AXLE HUB & BEARING ASSY LH
a. Remove the 4 bolts and then remove the rear axle hub & bearing assy LH.
5. INSTALL REAR AXLE HUB & BEARING ASSY LH
a. Install the rear axle hub & bearing assy LH on the axle beam assy with 4 bolts.
Torque: 61 Nm (622 kgf-cm, 45 ft. lbs.)
6. CONNECT SKID CONTROL SENSOR WIRE
a. Connect the skid control sensor connector.
7. INSPECT AXLE HUB BEARING LOOSENESS
8. INSPECT AXLE HUB BEARING RUNOUT
9. INSTALL REAR BRAKE DRUM SUB-ASSY
10. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
11. INSPECT REAR WHEEL ALIGNMENT
12. CHECK ABS SPEED SENSOR SIGNAL