Luggage Compartment Door (Coupe)

Luggage Compartment Door (Coupe):

OVERHAUL

HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- A bolt without a torque specification is shown in the standard bolt chart.




1. REMOVE LUGGAGE COMPONENT DOOR INSIDE HANDLE COVER
a. Using a screwdriver, disengage the 3 claws and remove the cover.

HINT: Tape the screwdriver tip before use.




2. REMOVE LUGGAGE COMPARTMENT DOOR HANDLE INSIDE
a. Using a screwdriver, disengage the 3 claws and remove the lever.

HINT: Tape the screwdriver tip before use.




3. REMOVE LUGGAGE COMPARTMENT DOOR COVER
a. Using a clip remover, remove the 16 clips and cover.




4. REMOVE LUGGAGE DOOR LOCK OPENER ASSY
a. Remove the rod as shown in the illustration.
b. Remove the screw and opener.




5. REMOVE LUGGAGE COMPARTMENT DOOR LOCK ASSY
a. Disconnect the connector and cable.
b. Remove the control rod.
c. Remove the 2 bolts and lock.

6. REMOVE REAR SPOILER SUB-ASSY
7. REMOVE LUGGAGE COMPARTMENT FLOOR MAT




8. REMOVE REAR FLOOR FINISH PLATE
a. Using a screwdriver, disengage the 7 clips and remove the rear floor finish plate.

HINT: Tape the screwdriver tip before use.




9. REMOVE LUGGAGE COMPARTMENT SIDE TRAY ASSY
a. Remove the bolt and tray.

10. REMOVE LUGGAGE COMPARTMENT TRIM COVER INNER LH
a. Using a clip remover, remove the 2 clips and trim.

11. REMOVE FRONT DOOR SCUFF PLATE LH
a. Using a screwdriver, disengage the 3 clips and remove the plate.

HINT: Tape the screwdriver tip before use.

12. REMOVE REAR SEAT ASSY
13. REMOVE QUARTER TRIM PANEL LOWER LH




14. REMOVE LUGGAGE DOOR LOCK OPEN BEZEL
a. Pull up at the rear edge of the bezel to disengage the clip.
b. Slide the bezel rearward to disengage the claw and remove the bezel.
c. The clip mentioned in step (a) will remain in the opener. Remove the clip and re-attach it to the bezel.

HINT: Tape the screwdriver tip before use.




15. REMOVE LUGGAGE DOOR LOCK OPEN LEVER SUB-ASSY
a. Remove the 2 bolts and lever. b.Disconnect the 2 cables.




16. REMOVE LUGGAGE OPENER CANCEL CYLINDER ASSY
a. Remove the bolt and cylinder.




17. REMOVE LUGGAGE DOOR LOCK CONTROL CABLE SUB-ASSY
a. Remove the cable as shown in the illustration (body side).




b. Remove the cable as shown in the illustration (luggage compartment door side).




18. INSTALL LUGGAGE OPENER CANCEL CYLINDER ASSY
a. Install the cylinder with the bolt.

Torque: 5.5 Nm (56 kgf.cm, 49 in.lbf)




19. INSTALL LUGGAGE DOOR LOCK OPEN LEVER SUB-ASSY
a. Connect the 2 cables.
b. Install the lever with the 2 bolts.

Torque: 5.5 Nm (56 kgf.cm, 49 in.lbf)




20. INSTALL LUGGAGE COMPARTMENT DOOR LOCK ASSY
a. Install the lock with the 2 bolts.

Torque: 5.5 Nm (56 kgf.cm, 49 in.lbf)

b. Install the control cable.
c. Connect the connector.