Convertible

Rear Seat Belt (Convertible) - Part 1:

Rear Seat Belt (Convertible) - Part 2:

REPLACEMENT

HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
- A bolt without a torque specification is shown in the standard bolt chart.
- CRS stands for child restraint seat.

1. REMOVE REAR SEAT CUSHION ASSY
2. REMOVE REAR SEAT HEADREST PLATE COVER RH
3. REMOVE REAR SEAT HEADREST PLATE COVER LH
4. REMOVE REAR SEAT HEADREST PLATE RH
5. REMOVE REAR SEAT HEADREST PLATE LH
6. REMOVE REAR SEAT HEADREST ASSY RH
7. REMOVE REAR SEAT HEADREST ASSY LH
8. REAR SEAT SHOULDER BELT COVER LH
9. REAR SEAT SHOULDER BELT COVER RH
10. REMOVE REAR SEATBACK ASSY
11. REMOVE FRONT DOOR SCUFF PLATE LH
12. REMOVE CUP HOLDER NO.1
13. REMOVE QUARTER TRIM PANEL SUB-ASSY UPPER LH
14. REMOVE QUARTER TRIM PANEL LOWER LH




15. REMOVE REAR SEAT OUTER BELT ASSY LH
a. Remove the 3 bolts and belt.




16. REMOVE REAR SEAT INNER BELT ASSY LH
a. Remove the nut and belt.




17. REMOVE CRS ANCHOR BRACKET
a. Remove the 2 nuts and bracket.

18. INSTALL CRS ANCHOR BRACKET
a. Install the bracket with the 2 nuts.

Torque: 18.1 Nm (185 kgf.cm, 13 ft.lbf)




19. INSTALL REAR SEAT INNER BELT ASSY LH
a. Install the belt with the nut, as shown in the illustration.

Torque: 42 Nm (428 kgf.cm, 31 ft.lbf)




20. INSTALL REAR SEAT OUTER BELT ASSY LH

NOTE: Do not disassemble the retractor.

a. Check the degree of tilt when the belt begins to lock the ELR.
1. When the inclination of the retractor is 15 ° or less, check that the belt can be pulled from the retractor. When the inclination of the inclination of the retractor is over 45 °,check that the belt locks.
If operation is not as specified, replace the belt assy.




b. Install the outer belt with the 3 bolts, as shown in the illustration.

Torque: 42 Nm (428 kgf.cm, 31 ft.lbf)

NOTE: Do not allow the anchor part of the rear belt and the protruding parts of the rear seat adjuster to overlap.

c. Check the ELR lock.

NOTE: The check should be performed with the outer belt assy installed.

1. With the belt installed, check that the belt locks when it is pulled out quickly.
If operation is not as specified, replace the belt assy.

d. Check fastening function of the child restraint system.

NOTE: The check should be performed with the outer belt assy installed.
1. When the belt is pulled out fully, the belt should automatically try to retract.
2. After the belt has fully retracted, the belt should be able to be pulled out and retracted again.
If operation is not as specified, replace the belt assy.