C1361

DTC C1361/91 Short Circuit in ABS Motor FAIL SAFE Relay Circuit

DESCRIPTION

DTC Detection Condition:

If a DTC of the motor line is stored, the ABS CUT (fail safe) relay cuts off the power supply to the ABS MTR relay and performs fail safe.

While any of the ABS, TRAC, VSC, or BA is operating, the skid control ECU (housed in the actuator assembly) turns the ABS MTR relay on and activates the pump motor in the brake actuator. This code may be stored if the motor relay (BM) voltage becomes lower than the DTC detecting condition due to insufficient output from the battery or alternator.

Wiring Diagram:

Step 1-3:

Step 3-4:

Step 5:

Step 6-7:

Step 7(Continued):

INSPECTION PROCEDURE

NOTE: When replacing the brake actuator assembly, perform zero point calibration. Calibration