Removal and Replacement

FRONT BUMPER

Front Bumper:

Front Bumper:

REMOVAL

HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- A bolt without a torque specification is shown in the standard bolt chart.

1. REMOVE FRONT FENDER LINER LH






a. Remove the 2 screws.
b. Partially remove the fender liner.

HINT: Although it is not necessary to remove the fender liner completely, remove it partially so that the bumper cover can be removed in later step.

2. REMOVE FRONT FENDER LINER RH

HINT: Use the same procedure for the RH side and LH side.

3. REMOVE FRONT BUMPER ASSEMBLY






a. Put protective tape under the front fender.
b. Remove the 7 screws, 2 bolts and 2 clips.
c. Using a screwdriver, disengage the 4 claws and remove the bumper cover.

HINT: Tape the screwdriver tip before use.

d. Disconnect the 2 fog light connectors.

INSTALLATION

1. INSTALL FRONT BUMPER ASSEMBLY
a. Connect each connector.
b. Engage each claw.






c. Install the front bumper assembly with the 7 screws, 2 bolts and 2 clips.

2. INSTALL FRONT FENDER LINER LH






a. Install the front fender liner LH with the 2 screws.

3. INSTALL FRONT FENDER LINER RH

HINT: Use the same procedure for the RH side and LH side.

4. VEHICLE PREPARATION FOR FOG LIGHT AIM ADJUSTMENT
5. PREPARATION FOR FOG LIGHT AIMING
6. FOG LIGHT AIMING INSPECTION
7. FOG LIGHT AIMING ADJUSTMENT