Removal and Replacement

REAR BUMPER

Rear Bumper:

Rear Bumper:

REMOVAL

HINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- A bolt without a torque specification is shown in the standard bolt chart.

1. REMOVE REAR FLOOR FINISH PLATE
2. REMOVE REAR BUMPER ASSEMBLY






a. Put protective tape under the quarter panel.
b. Remove the 4 clips, 2 screws and 4 nuts.
c. Using a screwdriver, disengage the 7 claws and remove the rear bumper.

HINT: Tape the screwdriver tip before use.

d. Disconnect the 2 license plate connectors.

INSTALLATION

1. INSTALL REAR BUMPER ASSEMBLY
a. Connect each connector.
b. Engage each claw.






c. Install the rear bumper assembly with the 2 screws, 4 nuts and 4 clips.

2. INSTALL REAR FLOOR FINISH PLATE