Rear Seat Assembly (Convertible)
REMOVALHINT:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- A bolt without a torque specification is shown in the standard bolt chart.
1. REMOVE REAR SEAT CUSHION ASSEMBLY
a. Pull up the 2 front portions of the seat cushion, then remove it.
NOTE: The cushion frame deforms easily. To avoid deforming the seat cushion, place your hands near the hook as shown in the illustration, and then pull up on the seat cushion. Do the same for the other hook.
2. REMOVE REAR SEAT HEADREST PLATE COVER
a. Using a screwdriver, disengage the 4 claws and remove the plate cover.
HINT: Tape the screwdriver tip before use.
3. REMOVE REAR SEAT HEADREST PLATE
a. Remove the 2 nuts.
b. Disengage the 6 claws and 2 clips. Then remove the plate.
4. REMOVE REAR SEAT HEADREST ASSEMBLY
5. REMOVE REAR SEAT SHOULDER BELT COVER LH
a. Using a screwdriver, disengage the claw and turn over the cover.
HINT: Tape the screwdriver tip before use.
b. Remove the screw.
c. Using a screwdriver, disengage the clip and claw. Then remove the belt cover.
HINT: Tape the screwdriver tip before use.
6. REMOVE REAR SEAT SHOULDER BELT COVER RH
HINT: Use the same procedures described for the LH side.
7. REMOVE REAR SEATBACK ASSEMBLY
a. Remove the 2 bolts and 2 rear seat outer belt anchors.
b. Remove the 2 bolts.
c. Remove the seatback in the direction indicated by the arrow in the illustration.
8. REMOVE REAR SEATBACK WIRE
a. Remove the 2 bolts and seatback wire.
INSTALLATION
1. INSTALL REAR SEATBACK ASSEMBLY
a. Install the seatback with the 2 bolts.
Torque: 18.1 N.m (185 kgf.cm, 13 ft.lbf)
b. Install the 2 rear seat outer belt anchors with the 2 bolts.
Torque: 42 N.m (428 kgf.cm, 31 ft.lbf)
2. INSTALL REAR SEAT CUSHION ASSEMBLY
a. Insert the inner belts through the slits on the seat cushion as shown in the illustration.
b. Attach the seat cushion's rear hook to the seatback assembly's hook.
c. Attach the seat cushion's 2 front hooks to the rear seat cushion lock hooks.
HINT: Confirm that the seat cushion is firmly installed.