Without Scan Tool

DTC CHECK (SST CHECK WIRE)

Check the DTC




1. Using SST, connect terminals TC and CG of the DLC3.
SST 09843-18040

2. Turn the ignition switch to the ON position.




3. Observe the blinking pattern of the ABS warning and VSC warning lights in order to identify the DTC.

HINT: If no code appears, inspect the TC and CG terminal circuit, and ABS and VSC warning light circuits.




4. As an example, the illustration shows the blinking patterns of the normal system code and trouble codes 11 and 21.
5. The codes are explained in the code table.
6. After completing the check, disconnect terminals TC and CG of the DLC3, and turn off the display If 2 or more DTCs are detected at the same time, the DTCs will be displayed in ascending order.

END OF DTC CHECK

a. Turn the ignition switch to the ON position.
b. Check that the ABS warning light goes off within approximately 3 seconds.