Blower Unit
DISASSEMBLY1. REMOVE CLEAN AIR FILTER
a. Release the 2 fitting claws and remove the air filter sub assembly.
b. Remove the clean air filter from the front cooler frame.
2. REMOVE COWL WIRE NO.2
a. Remove the clamp and cowl wire No. 2.
3. REMOVE RECIRCULATION DAMPER SERVO SUBASSEMBLY
a. Remove the 3 screws and air inlet servomotor (recirculation damper servo sub-assembly).
4. REMOVE INSTRUMENT PANEL WIRE NO.3
a. Manual A/C model:
Disconnect the 2 connectors and remove the 3 clamps and instrument panel wire No. 3.
b. Auto A/C model:
Disconnect the 2 connectors and remove the 2 clamps and instrument panel wire No. 3.
5. REMOVE BLOWER RESISTOR
a. Remove the 2 screws and blower resistor.
6. REMOVE BLOWER MOTOR CONTROL
a. Remove the 2 screws and blower motor control.
7. REMOVE BLOWER W/FAN MOTOR SUB-ASSEMBLY
a. Remove the 3 screws and blower w/ fan motor subassembly.
REASSEMBLY
1. INSTALL BLOWER W/FAN MOTOR SUB-ASSEMBLY
2. INSTALL BLOWER MOTOR CONTROL
3. INSTALL BLOWER RESISTOR
4. INSTALL INSTRUMENT PANEL WIRE NO.3
5. INSTALL RECIRCULATION DAMPER SERVO SUBASSEMBLY
6. INSTALL COWL WIRE NO.2
7. INSTALL CLEAN AIR FILTER