Blower Unit

Blower Unit:

Blower Unit

REMOVAL

HINT:
- Installation is in the reverse order of removal.
- COMPONENTS:

1. REMOVE INSTRUMENT PANEL SAFETY PAD
2. REMOVE HEATER TO FOOT DUCT NO.1
3. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY
4. REMOVE ECM
5. REMOVE BLOWER ASSEMBLY




a. Disconnect the connectors.
b. Remove the screw, clamp and blower connector holder.




c. Disconnect the 5 wire harness clamps.




d. w/ stereo component amplifier assembly:
Disconnect the 2 wire harness clamps.




e. Manual A/C model:
Disconnect the 4 connectors and remove the clamp.
f. Auto A/C model:
Disconnect the 3 connectors and remove the clamp.




g. Remove the 2 screws, 2 nuts and blower assembly.

INSTALLATION

1. INSTALL BLOWER ASSEMBLY




a. Install the blower assembly with the 2 screws and 2 nuts.

Torque: Nut 1.5 N.m (15 kgf.cm, 12 in.lbf)




b. Manual A/C model:
Install the clamp and connect the 4 connectors.

c. Auto A/C model:
Install the clamp and connect the 3 connectors.




d. w/ stereo component amplifier assembly:
Install the 2 wire harness clamps.




e. Install the 5 wire harness clamps.




f. Install the blower connector holder with the screw and clamp.
g. Connect the connectors.

2. INSTALL INSTRUMENT PANEL SAFETY PAD