Engine Control Module: Service and Repair

REMOVAL

1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE FRONT DOOR SCUFF PLATE RH (for Coupe)
3. REMOVE FRONT DOOR SCUFF PLATE RH
4. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
5. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH
6. REMOVE N0.1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
7. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL RH




8. REMOVE ECM
a. Remove the 2 wire harness clamps.
b. Disconnect the 5 ECM connectors.
c. Remove the 2 nuts and ECM.




9. REMOVE ECM BRACKET
a. Remove the 2 screws and ECM bracket.




10. REMOVE ECM BRACKET N0.2
a. Remove the 2 screws and ECM bracket.

INSTALLATION




1. INSTALL ECM BRACKET N0.2
a. Install the ECM bracket with the 2 screws.




2. INSTALL ECM BRACKET
a. Install the ECM bracket with the 2 screws.




3. INSTALL ECM
a. Install the 2 wire harness clamps.
b. Connect the 5 ECM connectors.
c. Install the ECM with the 2 nuts.

Torque: 5.5 N.m (56 kgf.cm, 49 in.lbf)

4. INSTALL INSTRUMENT PANEL FINISH LOWER PANEL RH
5. INSTALL INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY N0.1
6. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH
7. INSTALL FRONT DOOR SCUFF PLATE RH
8. CONNECT BATTERY NEGATIVE TERMINAL
9. INITIALIZE SYSTEM