Short in CAN Bus Lines

Short in CAN Bus Lines

DESCRIPTION




The CAN bus wires are considered to be shorted when the resistance between terminals 6 (CANH) and 14 (CANL) of the DLC3 is below 54 ohms.

Wiring Diagram:

Step 1:

Step 2-3:

Step 3 (Continued):

Step 3 (Continued):

Step 3 (Continued):

Step 3 (Continued)-4:

Step 5-7:

Step 7 (Continued)-8:

Step 8 (Continued)-9:

Step 9 (Continued)-10:

Step 10 (Continued)-11:

Step 11 (Continued)-12:

Step 13:

INSPECTION PROCEDURE

NOTE:
- Turn the ignition switch off before measuring the resistance of the CAN main wires and CAN branch wires.
- After the ignition switch is turned off, check that the key reminder warning system and light reminder warning system are not operating.
- Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT: Operating the ignition switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.