Evaporative Emission Control Canister: Service and Repair

REMOVAL

1. REMOVE FUEL TANK ASSEMBLY




2. REMOVE CHARCOAL CANISTER ASSEMBLY
a. Disconnect the fuel tank vent hose from the charcoal canister.
1. Push the connector deep inside.
2. Pinch portion A.
3. Pull out the connector.




b. Disconnect the charcoal canister filter sub-assembly from the charcoal canister.
1. Push the connector deep inside.
2. Pinch portion A.
3. Pull out the connector.

c. Disconnect the vapor pressure sensor connector.
d. Disconnect the wire harness clamp.
e. Disconnect the purge line hose from the charcoal canister.




f. Remove the 2 bolts, clip and charcoal canister.

INSTALLATION




1. INSTALL CHARCOAL CANISTER ASSEMBLY
a. Install the 2 bolts, clip and charcoal canister.

Torque: 39 N.m (398 kgf.cm, 29 ft.lbf)

b. Connect the purge line hose to the charcoal canister.
c. Connect the wire harness clamp.
d. Connect the vapor pressure sensor connector.




e. Connect the charcoal canister filter sub-assembly to the charcoal canister.




f. Connect the fuel tank vent hose to the charcoal canister.

2. INSTALL FUEL TANK ASSEMBLY