Curtain Shield Airbag Assembly

Curtain Shield Airbag Assembly:

Curtain Shield Airbag Assembly

REMOVAL

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. PRECAUTION, refer to Restraint Systems Service Precaution

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Work must be started at least 90 seconds after the ignition switch is turned off and after the cable is disconnected from the negative (-) battery terminal.

3. REMOVE ROOF HEADLINING ASSEMBLY

HINT: Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY.

4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY




a. Remove the 9 bolts and the curtain shield airbag assembly in the order shown in the illustration.
b. Disconnect the connector from the curtain shield airbag assembly.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

INSTALLATION

1. INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

a. Check that the ignition switch is in the OFF position.
b. Check that the cable is connected to the negative (-) battery terminal is disconnected.

CAUTION: Work must be started at least 90 seconds after the ignition switch is turned off and after the cable is disconnected from the negative (-) battery terminal.

c. Connect the connector to the curtain shield airbag assembly.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.




d. Install the curtain shield airbag assembly with the 9 bolts in the order shown in the illustration.

Torque: 9.8 N.m (100 kgf.cm, 87 in.lbf)

NOTE: Do not twist the curtain shield airbag assembly when installing it.

2. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY
3. INSTALL ROOF HEADLINING ASSEMBLY

HINT: Refer to the procedures up to "INSTALL ROOF HEADLINING ASSEMBLY.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
5. PERFORM INITIALIZATION

a. Perform initialization.

HINT: Some systems need initialization after reconnecting the cable to the negative battery terminal.

6. INSPECT SRS WARNING LIGHT

a. Inspect the SRS warning light