Diesel Data: Automotive Repair
Home >> Toyota >> 2007 >> Solara Convertible V6-3.3L (3MZ-FE) >> Repair and Diagnosis >> Restraints and Safety Systems >> Air Bag Systems >> Air Bag >> Service and Repair >> Removal and Replacement >> Front Passenger Airbag Assembly

Front Passenger Airbag Assembly

Front Passenger Airbag Assembly:




Front Passenger Airbag Assembly

REMOVAL

HINT: Installation is in the reverse order of removal.

1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
3. REMOVE STEERING WHEEL COVER LOWER NO.2
4. REMOVE STEERING WHEEL COVER LOWER NO.3.
5. REMOVE STEERING PAD.
6. REMOVE STEERING WHEEL ASSEMBLY.

SST 09950-50013 (09951-05010, 09952-05010, 09953-05020, 09954-05021)

7. REMOVE STEERING COLUMN COVER LOWER
8. REMOVE STEERING COLUMN COVER.
9. REMOVE SPIRAL CABLE SUB-ASSEMBLY.
10. REMOVE INSTRUMENT PANEL UNDER COVER SUBASSEMBLY NO.1.
11. REMOVE INSTRUMENT PANEL FINISH LOWER PANEL RH.
12. DISCONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR




a. Disconnect the connectors from the front passenger airbag assembly.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

13. REMOVE INSTRUMENT PANEL SAFETY PAD SUBASSEMBLY.
14. REMOVE DEFROSTER NOZZLE ASSEMBLY.
15. REMOVE HEATER TO REGISTER DUCT NO.1.
16. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY




a. Remove the 2 screws.




b. Release the front side wall of the airbag door from the hook by slightly deflecting it and roll the front passenger airbag assembly rearward.
c. Release the rear side wall of the airbag door from the other hook and remove the front passenger airbag assembly.

INSTALLATION

1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
2. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY.
3. INSTALL INSTRUMENT PANEL SAFETY PAD SUBASSEMBLY.
4. CONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR




a. Connect the connectors to the front passenger airbag assembly.

NOTE: When handling the airbag connector, take care not to damage the airbag wire harness.

5. INSTALL SPIRAL CABLE SUB-ASSEMBLY.
6. ADJUST SPIRAL CABLE SUB-ASSEMBLY
7. INSTALL STEERING WHEEL ASSEMBLY.
8. INSPECT STEERING WHEEL CENTER POINT
9. INSTALL STEERING PAD.
10. CONNECT BATTERY NEGATIVE TERMINAL

NOTE: When disconnecting the negative (-) battery terminal, initialize the following systems after the terminal is reconnected.

System Name
Power Window Control System
Sliding Roof System

11. INSPECT STEERING PAD
12. INSPECT SRS WARNING LIGHT
Diesel-Data.com