Removal

2GR-FE ENGINE CONTROL SYSTEM: ECM:

REMOVAL

1. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH (Removal)

2. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH (Removal)

3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH (Removal)

4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH (Removal)

5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (Removal)

6. REMOVE WINDSHIELD WIPER MOTOR AND LINK (Removal)

7. REMOVE COWL TOP OUTER PANEL SUB-ASSEMBLY (Removal)

8. REMOVE ECM

(a) Remove the 3 nuts.
(b) Disconnect the 2 ECM connectors and remove the ECM.

(1) Raise the 2 levers while pushing the locks on the 2 levers, and disconnect the 2 ECM connectors.

NOTE: After disconnecting the connector, make sure that dirt, water and other foreign matter do not contact the connecting part of the connector.

(2) Remove the ECM.