Installation

SUPPLEMENTAL RESTRAINT SYSTEM: CENTER AIRBAG SENSOR ASSEMBLY:

INSTALLATION

1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY
(a) Check that the ignition switch is off.
(b) Check that the battery negative (-) cable is disconnected.

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.





(c) Install the center airbag sensor assembly with the 3 bolts.
Torque: 17.5 Nm (179 kgf-cm, 13 ft-lbf)

- If the center airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
- When installing the center airbag sensor assembly, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.

(d) Check that there is no looseness in the installation parts of the center airbag sensor assembly.
(e) Connect the holder (with connectors).
(f) Check that the water-proof sheet is properly set.
2. INSTALL NO. 1 CONSOLE BOX DUCT (for Automatic Air Conditioning System) (Installation)

3. INSTALL NO. 2 CONSOLE BOX INSERT FRONT (Installation)

4. INSTALL NO. 1 CONSOLE BOX INSERT FRONT (Installation)

5. INSTALL CONSOLE BOX ASSEMBLY (Installation)

6. INSTALL CONSOLE BOX CARPET (Installation)

7. INSTALL CONSOLE BOX POCKET (Installation)

8. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY (Installation)

9. INSTALL INSTRUMENT PANEL NO. 2 UNDER COVER SUB-ASSEMBLY (Installation)

10. INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (Installation)

11. INSTALL FRONT DOOR SCUFF PLATE RH (Installation)

12. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (Installation)

13. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (Installation)

14. INSTALL FRONT DOOR SCUFF PLATE LH (Installation)

15. INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY (Installation)

16. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Manual Transaxle) (Installation)

17. INSTALL UPPER CONSOLE REAR PANEL SUB-ASSEMBLY (for Automatic Transaxle) (Installation)

18. INSTALL UPPER CONSOLE PANEL (for Manual Transaxle) (Installation)

19. INSTALL FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY (for Automatic Transaxle) (Installation)

20. INSTALL NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH (Installation)

21. INSTALL NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH (Installation)

22. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Manual Transaxle) (Installation)

23. INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transaxle) (Installation)

24. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
25. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light (Diagnosis System).