Installation

BRAKE: STOP LIGHT SWITCH:

INSTALLATION

1. INSTALL STOP LIGHT SWITCH





(a) Insert the stop light switch assembly until the body hits the cushion.

NOTE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.





(b) Make a quarter turn clockwise to install the stop light switch assembly.
Torque: 1.5 Nm (15 kgf-cm, 13 in-lbf)

NOTE: When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.





(c) Connect the stop light switch connector to the stop light switch assembly.
(d) Check the protrusion of the rod (On-Vehicle Inspection).
2. INSTALL COMBINATION METER (Installation)

3. INSTALL INSTRUMENT CLUSTER FINISH NO.1 PANEL (Installation)

4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Key System) (Installation)

5. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Key System) (Installation)

6. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (Installation)

7. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL LH (Installation)

8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY (Installation)

9. INSTALL FRONT DOOR SCUFF PLATE (Installation)