Installation

P112 HYBRID VEHICLE CONTROL: HYBRID VEHICLE CONTROL ECU:

INSTALLATION

1. INSTALL HYBRID VEHICLE CONTROL ECU





(a) Install the hybrid vehicle control ECU with the 2 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 in-lbf)
2. INSTALL ECM (Installation)

3. INSTALL NO. 3 HEATER TO REGISTER DUCT

4. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY

5. CONNECT AIRBAG CONNECTOR
6. INSTALL FRONT PILLAR GARNISH RH
7. INSTALL FRONT PILLAR GARNISH LH
8. INSTALL FRONT PILLAR GARNISH CORNER PIECE RH
9. INSTALL FRONT PILLAR GARNISH CORNER PIECE LH
10. INSTALL NO. 1 INSTRUMENT PANEL SPEAKER PANEL
11. INSTALL GLOVE COMPARTMENT DOOR

12. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY

13. INSTALL GLOVE COMPARTMENT DOOR STOPPER
14. INSTALL MULTI-DISPLAY ASSEMBLY
15. INSTALL NO. 2 INSTRUMENT PANEL REGISTER

16. INSTALL NO. 4 INSTRUMENT PANEL REGISTER

17. INSTALL NO. 3 INSTRUMENT PANEL REGISTER

18. INSTALL UPPER INSTRUMENT PANEL FINISH PANEL

19. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL

20. INSTALL NO. 1 INSTRUMENT PANEL REGISTER

21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

22. CHECK SRS WARNING LIGHT
23. INSTALL REAR NO. 3 FLOOR BOARD

24. INSTALL REAR DECK FLOOR BOX

25. INSTALL REAR NO. 2 FLOOR BOARD

26. PERFORM INITIALIZATION
(a) Perform initialization (Repair Instruction - Initialization).

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.