Removal

P112 HYBRID VEHICLE CONTROL: HYBRID VEHICLE CONTROL ECU:

REMOVAL

1. REMOVE REAR NO. 2 FLOOR BOARD

2. REMOVE REAR DECK FLOOR BOX

3. REMOVE REAR NO. 3 FLOOR BOARD

4. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

5. REMOVE NO. 1 INSTRUMENT PANEL REGISTER

6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL

7. REMOVE UPPER INSTRUMENT PANEL FINISH PANEL

8. REMOVE NO. 3 INSTRUMENT PANEL REGISTER

9. REMOVE NO. 4 INSTRUMENT PANEL REGISTER

10. REMOVE NO. 2 INSTRUMENT PANEL REGISTER

11. REMOVE MULTI-DISPLAY ASSEMBLY

12. REMOVE GLOVE COMPARTMENT DOOR STOPPER

13. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

14. REMOVE GLOVE COMPARTMENT DOOR

15. REMOVE NO. 1 INSTRUMENT PANEL SPEAKER PANEL
16. REMOVE FRONT PILLAR GARNISH CORNER PIECE RH
17. REMOVE FRONT PILLAR GARNISH CORNER PIECE LH
18. REMOVE FRONT PILLAR GARNISH RH
19. REMOVE FRONT PILLAR GARNISH LH
20. DISCONNECT AIRBAG CONNECTOR
21. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

22. REMOVE NO. 3 HEATER TO REGISTER DUCT

23. REMOVE ECM (Removal)

24. REMOVE HYBRID VEHICLE CONTROL ECU





(a) Remove the 2 nuts and hybrid vehicle control ECU.