Installation

1NZ-FXE EMISSION CONTROL: AIR FUEL RATIO SENSOR:

INSTALLATION





1. INSTALL AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)
(a) Using SST, install the sensor.
SST: 09224-00010
Torque: 44 Nm (449 kgf-cm, 32 ft-lbf) for use with SST
Torque: 40 Nm (408 kgf-cm, 30 ft-lbf) for use without SST

HINT: Use a torque wrench with a fulcrum length of 30 cm (11.81 in.).

(b) Connect the sensor connector.
(c) Install the wire harness clamp to the sensor.
2. INSTALL CONVERTER WITH INVERTER ASSEMBLY (Installation)

3. CONNECT FRAME WIRE (Installation)

4. CONNECT NO. 1 CIRCUIT BREAKER SENSOR (Installation)

5. CONNECT NO. 6 INVERTER COOLING HOSE
6. CONNECT NO. 1 INVERTER COOLING HOSE
7. CONNECT NO. 2 INVERTER COOLING HOSE
8. INSTALL INVERTER COVER (Installation)

9. INSTALL FRONT COWL TOP PANEL OUTER (Installation)

10. INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

11. INSTALL COWL TOP VENTILATOR LOUVER RH
12. INSTALL COWL TOP VENTILATOR LOUVER LH
13. INSTALL HOOD TO COWL TOP SEAL
14. INSTALL FRONT WIPER ARM LH

15. INSTALL FRONT WIPER ARM RH

16. INSTALL FRONT WIPER ARM COVER
17. INSTALL REAR NO. 3 FLOOR BOARD

18. INSTALL REAR DECK FLOOR BOX

19. INSTALL REAR NO. 2 FLOOR BOARD

20. INSTALL SERVICE PLUG GRIP (Installation)

21. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

22. ADD COOLANT (for Inverter) (Coolant).

23. INSPECT FOR COOLANT LEAK (for Inverter) (Coolant).

24. INSTALL ENGINE UNDER COVER RH
25. INSTALL ENGINE UNDER COVER LH
26. INSTALL RADIATOR SUPPORT OPENING COVER (Testing and Inspection)

27. PERFORM INITIALIZATION
(a) Perform initialization (Repair Instruction - Initialization).

NOTE: Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.