Removal

SEAT: FRONT SEAT ASSEMBLY (for Power Seat):

COMPONENTS









REMOVAL

CAUTION: Wear safety gloves, because the sharp surfaces of the seat adjuster may injure your hand.

NOTICE:
- The installation procedures are the removal procedures in reverse order. However, only installation procedures requiring additional information are included.
- A bolt without a torque specification is shown in the standard bolt chart.

1. REMOVE SEAT TRACK COVER RH
2. REMOVE SEAT TRACK BRACKET COVER INNER LH
3. REMOVE FRONT SEAT ASSEMBLY LH

HINT: Set the power seat front vertical function to the highest position.

(a) Remove the headrest.
(b) Remove the 4 bolts and seat.
(c) Disconnect the negative battery's terminal.

CAUTION: Work must be started more than 90 seconds after the ignition switch is turned to the LOCK position and the negative (-) terminal cable is disconnected from the battery.

(The SRS is equipped with a back-up power source. If work is started within 90 seconds from turning the ignition switch to the Lock position and disconnecting the negative (-) terminal cable of the battery, the SRS may deploy.)

(d) Disconnect the connectors under the seat and remove the seat.

NOTE: Be careful not to damage the vehicle body.