Installation

BRAKE CONTROL: SKID CONTROL SENSOR:

INSTALLATION

1. INSTALL SKID CONTROL SENSOR





(a) Clean the contact surface of the axle hub and a new skid control sensor.

NOTE: Prevent foreign matter from attaching to the sensor rotor.

(b) Place the skid control sensor on the axle hub so that the connector is positioned as shown in the illustration.





(c) Using SST and a press, install the skid control sensor to the axle hub.

- Do not tap the skid control sensor with a hammer directly.
- Check that there should be no foreign matter on the skid control sensor detection portion.
- Press in the skid control sensor straight and slowly.

2. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH





(a) Install the rear axle hub & bearing assembly with the 4 bolts.
Torque: 80 Nm (816 kgf-cm, 59 ft-lbf)
3. INSTALL REAR DISC





(a) Aligning the matchmarks, install the rear disc.

HINT: When replacing the rear disc with a new one, select the installation position where the rear disc has the minimum runout.

4. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH

HINT: (Disassembly)

5. CONNECT SKID CONTROL SENSOR WIRE
(a) Connect the connector to the skid control sensor.
6. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft-lbf)
7. INSPECT AND ADJUST REAR WHEEL ALIGNMENT

HINT: (Service and Repair)

8. CHECK ABS SPEED SENSOR SIGNAL

HINT: (Test Mode Procedure) for ABS system, (Test Mode Procedure) for VSC system