Disassembly

PARKING BRAKE: PARKING BRAKE ASSEMBLY:

DISASSEMBLY

HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.

1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
(a) Remove the 2 bolts and separate the rear disc brake caliper assembly LH.

HINT: Do not disconnect the flexible hose from the disc brake caliper assembly LH.

3. REMOVE REAR DISC





(a) Release the parking brake, and remove the rear disc.

HINT: If the disc cannot be removed easily, turn the shoe adjuster until the wheel turns freely.





(b) Place machmarks on the rear disc and the axle hub.
(c) Remove the rear disc.
4. REMOVE PARKING BRAKE SHOE RETURN TENSION SPRING





(a) Using needle-nose pliers, remove the 2 parking brake shoe return tension springs No.1.
5. REMOVE PARKING BRAKE SHOE STRUT LH
(a) Remove the parking brake shoe strut LH and the parking brake shoe strut compression spring.
6. REMOVE PARKING BRAKE SHOE





(a) Release the cup claw and remove the parking brake shoe assembly LH No.2 and parking brake shoe assembly LH No.1.
(b) Disconnect the parking brake cable No.3 from the shoe lever.
(c) Remove the tension spring and shoe adjuster screw set from the parking brake shoe assembly LH No.2 and parking brake shoe assembly LH No.1.
(d) Remove the 2 shoe hold-down springs, 4 cups and 2 pins.





(e) Using a screwdriver, remove the C-washer.
(f) Remove the shim and shoe lever from the parking brake shoe assembly LH No.2.
7. REMOVE PARKING BRAKE SHOE GUIDE PLATE





(a) Remove the parking brake shoe guide plate set bolt and the parking brake shoe guide plate.