Installation

3MZ-FE ENGINE MECHANICAL: ENGINE REAR OIL SEAL:

INSTALLATION

1. INSTALL ENGINE REAR OIL SEAL





(a) Apply MP grease to a new oil seal lip.

NOTE: Keep the lip free from foreign matter.

(b) Using SST and a hammer, tap in the oil seal until its surface is flush with the rear oil seal retainer edge.
SST: 09223-15030
SST: 09950-70010
09951-07100

NOTICE:
- Be careful not to tap the oil seal at an angle.
- Wipe off extra grease from the crankshaft.

2. INSTALL DRIVE PLATE & RING GEAR SUB-ASSEMBLY





(a) Using SST, hold the crankshaft.
SST: 09213-54015
91651-60855
SST: 09330-00021
(b) Clean the bolts and bolt holes.
(c) Apply adhesive to 2 or 3 threads of the bolts.
Adhesive:
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
(d) Install the front spacer, drive plate and rear spacer on the crankshaft.





(e) Uniformly install and tighten the 8 bolts in the sequence shown in the illustration.
Torque: 83 Nm (846 kgf-cm, 61 ft-lbf)

NOTE: Do not start the engine for at least an hour after installing.

3. INSTALL AUTOMATIC TRANSAXLE ASSEMBLY

HINT: (Installation)