Installation

AIR CONDITIONING: CONDENSER:

INSTALLATION

1. INSTALL COOLER CONDENSER BRACKET NO.2





(a) Install the cooler condenser bracket No.2 with the bolt.
Torque: 4.4 Nm (45 kgf-cm, 39 in-lbf)
2. INSTALL COOLER CONDENSER BRACKET NO.1





(a) Install the cooler condenser bracket No.1 with the bolt.
Torque: 4.4 Nm (45 kgf-cm, 39 in-lbf)
3. INSTALL COOLER CONDENSER ASSEMBLY





(a) Install the cooler condenser assembly with the 2 nuts.
Torque: 9.8 Nm (100 kgf-cm, 85 in-lbf)

HINT: If the condenser is replaced with a new one, add compressor oil to the new condenser.

Capacity:
40 cc (1.4 fl. oz.)
Compressor oil:
ND-8 or equivalent
4. INSTALL RADIATOR SUPPORT UPPER

HINT:
- 2AZ-FE (Installation)
- 3MZ-FE (Installation)

5. INSTALL COOLER REFRIGERANT LIQUID PIPE A
(a) Remove the attached vinyl tape from the tube and connecting part of the cooler condenser assembly.
(b) Sufficiently apply compressor oil to a new O-ring and pipe joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring to the cooler refrigerant liquid pipe A.





(d) Connect the cooler refrigerant liquid pipe A to the cooler condenser assembly with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 47 in-lbf)
6. INSTALL COOLER REFRIGERANT DISCHARGE HOSE NO.1
(a) Remove the attached vinyl tape from the tube and connecting part of the cooler condenser assembly.
(b) Sufficiently apply compressor oil to a new O-ring and hose joint.
Compressor oil:
ND-OIL 8 or equivalent
(c) Install the O-ring to the cooler refrigerant discharge hose No.1.





(d) Connect the cooler refrigerant discharge hose No.1 to the cooler condenser assembly with the bolt.
Torque: 5.4 Nm (55 kgf-cm, 47 in-lbf)
7. CHARGE REFRIGERANT (Service and Repair)

8. WARM UP ENGINE (Service and Repair)

9. INSPECT FOR REFRIGERANT LEAK (Service and Repair)