Operation Check

LIGHTING SYSTEM: OPERATION CHECK

OPERATION CHECK

1. ILLUMINATED ENTRY SYSTEM OPERATION CHECK
(a) Illuminated entry system controls the following lights:

- Ignition key cylinder light (Transponder key amplifier)
- Interior light (Room light assembly No.1)
- Map light assembly (convertible only)

(b) Check that the lights come on after:
(1) Unlocking any door that was closed and locked with the ignition switch off
(c) Check that the lights fade out after:
(1) Leaving the doors unlocked for 15 seconds
(2) Turning the ignition switch to the ACC or ON position
(3) Locking all the doors
(d) Check that the lights stay ON for at least 15 seconds after opening any of the doors, then fade out again after 15 seconds.
(e) Check that the lights come on after:
(1) Closing all the doors and turning the ignition switch from the ACC or ON position off.
(f) Check that the lights fade out after:
(1) Leaving the doors unlocked for 15 seconds
(2) Locking all the doors
(g) Check that the lights stay ON for at least 15 seconds after opening any of the doors, then fade out again in 15 seconds after closing all the doors.
(h) Check that the lights come on when opening any of the doors and fade out after either closing and locking them or turning the ignition switch to the ACC or ON position.
2. BATTERY SAVER OPERATION CHECK
(a) Remove the ignition key and close all doors.
(b) Open any door to turn the room light on, and leave it open. Check that the light goes off in approximately 20 minutes.
(c) After the room light goes off, close the driver's door.
(d) Open any door to turn the room light on, and then open another door. Check that the room light goes off within 20 minutes after opening the doors.
(e) Close all doors. With the ignition key inserted, open any door to turn the room light on, and then remove the ignition key. Check that the room light goes off within 20 minutes.
3. LIGHT AUTO TURN OFF OPERATION CHECK
(a) Turn the ignition switch to the ON position, and switch the headlights into the TAIL or HEAD position.
(b) Turn the ignition switch off and open the driver's door, and check that the headlights go off after approximately 30 seconds.
(c) Turn the ignition switch to the ON position, and switch the headlights to the TAIL or HEAD position.
(d) Turn the ignition switch off and open the driver's door. Before the headlights go off after approximately 30 seconds, lock all doors. Check that the headlights go off immediately.
4. AUTOMATIC LIGHT CONTROL OPERATION CHECK
(a) Turn the ignition switch to the ON position.
(b) Turn the headlight dimmer switch to the AUTO position.
(c) Cover the automatic light control sensor and check that the tail light and headlight in order.
(d) Uncover the automatic light control sensor and check that the headlight and tail light go off in order.
5. DAYTIME RUNNING LIGHT OPERATION CHECK
(a) Check that the high beams come on when the headlight switch is off with the engine running and parking brake released (A).
(b) Check that the high beams go off when turning the headlight dimmer switch into the TAIL or HEAD (LOW) position under the condition as shown in "A".
(c) Check that the high beams go off when turning the ignition switch off under the condition as shown in "A".